Flowmeters

ADMAG AXF Magnetic Flowmeter

Measures the flows of ultra-low conductivity fluids up to 0.01 μS/cm.
stable measurement free from the effects of build-up of insulating material or coating, and noise of high-density slurry fluid.
Maintenance costs greatly reduced.

Spectral signal processing automatically optimizes the settings at all times, from immediately after power-on.
Self-diagnostics, one step ahead of other flowmeters, enables predictive maintenance.
Simultaneous analog and pulse signal outputs.
High-temperature and cryogenic models also available.

Built-in temperature sensor within the shedder bar offers the mass flow output or the temperature output.
No installation of the temperature device is needed for the process.
Durable meter design mostly meets the steam flow such as water hammer, high temperature process, etc.

Fully compensated mass flow: all flow factors can be automatically and dynamically calculated to an optimal value.
1.0% mass flow rate accuracy over 1:10 flow range.
Simultaneous dual output of 4 to 20 mA and pulse signals for total flow, flow rate, or alarm status.

Maximum two flow-input channels enable two path measurement or the measurement of two different flows in different pipes. The pipe sizes from 25 mm to 6,500 mm (1 to 255 inches).
With the noise suppression technique, the measurement against air bubbles in the fluid has been vastly improved
With the original signal processing, fast and accurate measurement has been realized.
The transducers are calibrated one by one when shipped and easy to install at the sites. It is not necessary to adjust zero flow condition, which has been often said to be necessary.
US300PM portable type is equipped with wall thickness measurement function.

Mass flow for nearly all flowing fluids.
Highly independent from external loads or vibrations through special decoupling system.
Precise flow and density measurement.
Wide temperature range ( 200°C to 350°C).